 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| SA1469TN 4-CH BTL DRIVER FOR CD PLAYER WITH 3.3V OUTPUT VOLTAGE DESCRIPTION The SA1469TN, an IC for CD players, has a 4-channel BTL driver, 3.3V regulator (attached PNP transistor required), standard operational amplifier, and internal reset output linked to an internal thermal shutdown circuit. The driver has gain adjustment input pins for each channel, allowing gain to be set to the desired value. Also, the internal level shift circuit helps reduce the number of attached components. FEATURES * 1-phase, full-wave, linear DC motor driver. * Gain is adjustable with an attached resistor. * Internal standard operational amplifier. * Internal 3.3V regulator. (required attached PNP transistor) * Internal thermal shutdown circuit with hysteresis capabilities. * When voltage of PIN23<0.7V(typ.),the driver will be muted. HSOP - 28-375-0.8 ORDERING INFORMATION Device SA1469TN Package HSOP-28-375-0.8 BLOCK DIAGRAM HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn REV:1.2 2008.07.23 Page 1 of 11 SA1469TN ABSOLUTE MAXIMUM RATING (Tamb=25C, unless otherwise specified) Characteristic Supply Voltage Power Dissipation Operating Temperature Storage Temperature Maximum Output Current Symbol VCC PD Topr Tstg Imax Value 18 1.7(Note) -40~+85 -55~+150 1 Unit V W C C A Note: 1. When mounted on 76mm x 114mm x 1.57mm PCB (Phenolic resin material). 2. Power dissipation reduces 13.6mW / C for using above Tamb=25 C. 3. Do not exceed Pd and SOA (Safe Operating Area). 2.0 1.5 1.0 0.5 0 0 25 50 75 100 125 150 175 Ambient temperature: ( Tamb ) ELECTRICAL CHARACTERISTICS (Tamb=25C, VCC=8.0V, unless otherwise specified) Parameter A REGULATOR PART Regulator Output Voltage Load Regulation Line Regulation B DRIVER PART Quiescent Circuit Current Input Offset Voltage Output Offset Voltage Maximum Sink Current Maximum Source Current Maximum Output Voltage (P4/P9/P20/P24 input) Closed Loop Voltage Gain Ripple Rejection Ratio Slew Rate VOM A/F RR SR ICCQ VOF VOO ISINK ISOU VI=0 RL=4, VCC RL=4, GND VI=2VRMS, 1KHz, RL=8 VI=2VRMS, 1KHz, RL= VI=0.1VRMS, 1kHz VI=-20dB, 120Hz 100Hz, squarewave 5.5 -5.0 -30 0.5 0.5 4.3 5.4 7.0 60.0 1.0 9.5 0 0 0.8 0.8 4.5 5.6 8.0 80.0 2.0 13.5 5.0 30 --4.6 5.8 9.0 --mA mV mV A A V V dB dB V/s VREG VRL VCC IL=100mA IL=0mA to 200mA IL=200mA, VCC=6 to 9V 3.13 -40.0 -10.0 3.3 0 0 3.47 10.0 20.0 V mV mV Symbol Test conditions Min. Typ. Max. Unit HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn REV:1.2 2008.07.23 Page 2 of 11 SA1469TN Parameter C OP AMP Input Offset Voltage Input Bias Current High Level Output Voltage Low Level Output Voltage Output Sink Current Output Source Current Open Loop Voltage Gain Ripple Rejection Ratio Slew Rate Common Mode Rejection Ratio VOF1 IB1 VOH1 VOL1 ISINK1 ISOURCE1 GVO1 RR1 SR CMRR1 RL=50, GND RL=50, VCC VIN=-75dB, f=1KHz VIN=-20dB, 120Hz Square, VOUT=2Vp-p, f=120KHz VIN=-20dB, 1KHz -5.0 -6 10 10 65 50 0.5 70 0 -40 50 78 70 1 84 5.0 300 1.8 mV nA V V mA mA dB dB V/s dB Symbol Test conditions Min. Typ. Max. Unit PIN CONFIGURATION PIN DESCRIPTION Pin No. 1 2 3 4 5 6 7 8 9 10 11 Symbol OUT1A OUT1B IN1A IN1B REG REO MUTE GND IN2B IN2A OUT2B O I -I I O I/O O O I I Drive output Drive output Drive input Drive input Regulator Regulator output Mute Ground Drive input Drive input Drive output Description HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn REV:1.2 2008.07.23 Page 3 of 11 SA1469TN Pin No. 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 Symbol OUT2A GND OPOUT OPIN (-) OPIN (+) OUT3A OUT3B IN3A IN3B VCC VCC VREF IN4B IN4A OUT4B OUT4A GND I/O O -O I I O O I I --I I I O O -Drive output Ground Opamp output Opamp input (-) Opamp input (+) Drive output Drive output Drive input Drive input Supply voltage Supply voltage 2.5V bias voltage Drive input Drive input Drive output Drive output Ground Description FUNCTIONAL DESCRIPTION 1. MUTE Function Thermal shutdown External muting VREF muting Mute T175C V(mute) 1.4V Or open PIN23 < 0.7V Operation conditions 1) The circuit is muted during thermal shutdown and during the mute-on state.In each case, only the drivers are muted. 2) 3) 4) 5) 6) During mute, the output pins remain at the internal bias voltage, roughly (Vcc-Vf)/2. When the mute pin # 7 is open or the voltage of the mute pin # 7 is below 0.5V, the mute circuit is activated so that the output circuit will be muted.. When the voltage of the mute pin is above 2V, the mute circuit is stopped and the output circuit is operated normally. If the chip temperature rises above 175C, then the TSD (Thermal Shutdown) circuit is activated and the output circuit is muted. When the voltage of PIN23<0.7V ,the output circuit will be muted. HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn REV:1.2 2008.07.23 Page 4 of 11 SA1469TN 2. TSD (THERMAL SHUTDOWN) 1) 2) 3) The VREF is the output voltage of the band-gap-referenced biasing circuit and acts as the input voltage of the TSD circuit. The base-emitter voltage of the TR, Qn is designed to turn-on at below voltage. VBE=VREF * R2/(R1+R2)=460mV When the chip temperature rises up to 175C, then the turn-on voltage of the Qn would drop down to 460mV. (Hysteresis: 25) and, the Qn would turn on so the output circuit will be muted. 3. OP-AMP OP-Amp is integrated in the IC for user convenuence. OPIN(+) OPIN(-) OPOUT Pins 14, 15 and 16 may be left open when the operational amplifier is not used. 4. DRIVER 1) 2) 3) 4) 5) 6) 7) 8) The voltage, VREF, is the reference voltage given by the BIAS voltage of the pin # 23. The input signal through the pin # 3 is amplified by 10K/10K times and then fed to the level shift. The level shift produces the current due to the difference between the input signal and the arbitrary reference signal. The current produced as +V and -V is fed into the driver buffer. Driver buffer operates the power TR of the output stage according to the state of the input signal. The output stage is the BTL driver and the motor is rotating in forward direction by operating TR Q1 and TR Q4. on the other hand, if TR Q2 and TR Q3 is operating, the motor is rotating in reverse direction. When the input voltage through the pin # 3 is below the VREF, then the direction of the motor in forward direction. When the input voltage through the pin # 3 is above the VREF, then the direction of the motor in reverse direction. If it is desired to change the gain, then the pin # 4 or # 24 can be used. HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn REV:1.2 2008.07.23 Page 5 of 11 SA1469TN 5. RADIATION FIN IS CONNECTING TO THE INTERNAL GND OF THE PACKAGE. Connect the fin to the external GND. 6. REGULATOR This is a typical series regulator that generates a reference voltage internally. A PNP low saturation type transistor must be connected. HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn REV:1.2 2008.07.23 Page 6 of 11 SA1469TN TEST CIRCUIT HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn REV:1.2 2008.07.23 Page 7 of 11 SA1469TN TYPICAL APPLICATION CIRCUIT ELECTRICAL CHARACTERISTICS CURVES Fig.1 Driver I/O characteristics (variable load) Fig.2 Driver I/O characteristics (variable power supply) HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn SA1469TN REV:1.2 2008.07.23 Page 8 of 11 SA1469TN ELECTRICAL CHARACTERISTICS CURVES(Continued) Fig. 3 Power supply voltage vs. output offset voltage Fig. 4 Driver gain vs. temperature (RIN connected via gain adjustment pin) Fig. 5 Regulator voltage vs. temperature Fig. 6 Load current vs. regulator voltage Fig. 7 Operational amplifier vs. open loop HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn REV:1.2 2008.07.23 Page 9 of 11 SA1469TN PACKAGE OUTLINE HSOP-28-375-0.8 UNIT: mm HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn REV:1.2 2008.07.23 Page 10 of 11 SA1469TN ATTACH Revision History Data 2007.08.03 2007.10.26 2008.07.23 REV 1.0 1.1 1.2 Original Add the" Power dissipation curve" Modify the "Electrical Characteristics " Modify the "Power dissipation curve" 2 Description Page HANGZHOU SILAN MICROELECTRONICS CO.,LTD Http://www.silan.com.cn REV:1.2 2008.07.23 Page 11 of 11 |
Price & Availability of SA1469TN
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |